Carries a roll of tile on the machine when traveling and plowing in wet and muddy conditions, eliminating ruts that occur when using a stringer tractor and wagon.
TILE PULLER
Provides consistent draw of tile from the reel. Can be swing-out or catwalk mounted.
MANUAL GREASE BANK
A safe and easier way to add grease to your pin points for both plow and axles.
REAR STEPS
Bolt-on steps to help the operator on and off the power unit. Available on left or right side.
MUD/ICE CLEATS
For added traction, ice/mud cleats are welded to existing single bar grousers.
PRE-HEAT SYSTEM
A timer-set heating motor that runs heated coolant through the engine and hydraulic tank, warms up the drive train and hydrostatic system for cold weather startup.
STEERING CONTROLS
Contractors have the choice of either dual or single stick steering.
CHUTES
Available in sizes 3" to 15" (7.62cm – 38.1cm). RWF BRON also designs and builds sand, gravel hoppers and custom made chutes.
CUTTER CRUSHER CHUTE
BRON’s unique design cuts and crushes the tile, saves time and money by eliminating the need for endcaps. Available in 4" and 6" (10.16cm – 15.24cm) sizes.
8" POWER FEEDER
Available in manual or hydraulic swing, avoids tile from stretching by mechanically feeding the tile into the chute.
GPS | LASER MAST LAY DOWN
Hydraulically raises and lowers the mast for transport purposes.
GPS | LASER MAST RAISER
Allows 4-feet of vertical travel, keeping your mast in the laser´s light.
TELESCOPING TRACKS
36” lateral movement avoids travelling over previously plowed soil.
OSCILLATING TRACK FRAME
Each track pivots independently allowing for continuous surface contact, resulting in maximum traction.
SELF-LEVELING
Hydraulic cylinders keep the entire tractor and plow level for perfect grading while traveling across sloped surfaces.
RWF Bron reserves the right to change specifications as necessary.
